SAFETY 2.1 SAFETY INSTRUCTIONS
35
INSTRUCTIONS FOR USE
Strap-Type Fall Absorber acc. to DIN EN 355 (Type E.K.N.-BFD)
Use
Within a fall-arrest system, the strap-type fall absorber (2) has to
be used in conjunction with a safety harness (1) acc. to DIN EN
361. The maximum length including the safety rope must not
exceed 2.0 m. For longer ropes, a rope-shortening device has to
be applied in addition.
Fix the rope to the attachment point and attach the strap-type fall
absorber to the catching hook in the back of the safety harness.
The attachment point should be above the wearer and its mini-
mum carrying capacity should be 10 KN, acc. to DIN EN 795.
The strap-type fall absorber and the safety rope must not be dam-
aged, e.g. never pull
them over sharp edges nor get them burnt by welding sparks.
Storing and maintenance
The strap-type fall absorber has to be kept dry in an airy and
shady room. It must not be ex-posed to acids, caustic chemicals,
nor to an aggressive atmosphere, and contact with oils has to be
avoided. If the strap-type fall absorber is dirty, it may be cleaned
with a little water and a light-duty detergent. Dry it in a shady
place (nowhere near fire or other sources of heat). Protect it from
sharp-edged objects.
Inspection
Prior to use, all parts have to be inspected for safe condition and
damages. At least once a year, the strap-type fall absorber has to
be tested by a competent person. A damaged or used strap-type
fall absorber has to be removed from service immediately. The
strap-type fall absorber must not be changed in any way. Repair
work has to be done by the
To Next Page