OPERATION 3.4 ELECTRONIC TEXT MONITORING SYSTEM ETM
93
3.4.2 SYSTEM COMPONENTS
see illust. Z 23090
Switches for the adjustments of the ETM system
OTICE
Settings with key switches (C and E) must only be done by
authorized Service Personnel. Refer to page 113 for setting
procedure.
(A) Text Display Unit
● Plaintext messages
● Multi-lingual text display
● Text store for all available texts
● Record memory capacity for max. 1300 mes-
sages
● Statistics memory for frequency and total time
period of the messages
(B) Key board with 8 keys
● Function of the keys, refer to page 91
(G) Acoustic warning signal
● Indicates fault messages
(F) Connector for printer ● Special equipment
(C) “Service” key switch for deletion of Record - and Statis-
tics memory contents
The erasure function is stored under message no. 30.
(D) Pre-selector switch for the following settings:
“0” - Off
“1” - Setting of Date
“2” - Setting of Time of day
“3” - Setting of Operating Hours
(E) Key switch, enables the settings selected with switch
(D). The adjustments are stored under message nos.
27, 28 and 29.
To Next Page