Konami Silent Scope - Page 53

51
Potentiometer bracket
Lock screws
Flat washer
Spring washer
Hexagon nut
Gear
Potentiometer
Code No. : 0000001723
Hole
Projection

Potentiometer bracket
Lock screws
Flat washer
Spring washer
Hexagon nut
Gear
Potentiometer
Code No. : 0000001723
Hole
Projection
How to adjust the rifle unit potetiometers
1 Fit the potentiometer projection to the smallest hole of the potemtiometer
bracket. Tighten up the hexagon nut.
2 Install the gear onto the shaft of the potentiometer. Tighten up the two lock
screws.
3 Align the potentiometer tip, as shown below.
4 Set the potentiometer bracket so that the mark on the potentiometer gear and
that on the mating gear be in alignment (see below). Also adjust the gears
into good mesh.
3 Align the potentiometer's slit
straight with the center terminal.
Center terminal
1 Align the mark on the gear
with the potentiometer's slit.
2 Tighten up the two lock screws.
Align the mark on the potentiometer gear with that
on the mating gear.
7 Maintenance
Align the mark on the potentiometer gear with that
on the mating gear.
Rifle unit up/down control potentiometer Rifle unit right/left control potentiometer
Rifle unit up/down control potentiometer Rifle unit right/left control potentiometer