501/421/361 3-16
Additional copy operations
3
6 Touch [OK] or [Cancel].
– To return to the Basic screen, press the [Mode Memory] key.
!
Detail
To stop registering the program, press the [Reset] key or the [Mode Memory] key.
No matter which screen is displayed, the registration is cancelled.
Otherwise, continue to touch [Cancel] until the Basic screen is displayed.
The settings of a copy program cannot be changed.
If the copy program that was selected has been locked, [Edit Name] and [Delete] do not appear. For
details, refer to "System Settings" on page 11-15.
3.5.1 Deleting a copy program
1 In the Recall Copy Program screen, touch the button for the copy program to be deleted.
– If the copy program to be recalled is not displayed, touch [↑] and [↓] until the desired copy program
is displayed.
2 Touch [Delete].
A message appears, requesting confirmation to delete the copy program.
3 Touch [Yes], and then touch [OK].
The Recall Copy Program screen appears again. The copy settings registered in the copy program are
erased.
To Next Page
Loading...
Need help?
General
