501/421/361 13-19
Authentication Unit (IC Card Type AU-201)
13
14 Click [Write].
– Data Administrator is equipped with a batch copy feature that allows the registered user data to be
specified on multiple multifunctional products specified to be used with this device.
The registered user data is specified on the multifunctional product.
15 Click [OK].
16 Disconnect this device from this USB port of the computer.
17 Turn off the multifunctional product with the main power switch, connect this device, and then turn on
the multifunctional product with the main power switch.
– When the multifunctional product is turned off, then on again with the main power switch, wait at
least 10 seconds to turn the machine on after turning it off. The machine may not operate correctly
if it is turned on immediately after being turned off.
– Hold the plug when plugging and unplugging the USB cable, otherwise the cable may be damaged.
13.4.3 Logging on to a multifunctional product
Follow the procedures described below to log on to multifunctional products by completing authentication
with IC card IDs.
When "Card Authentication” has been specified" has been specified
1 Position the registered IC card on this device.
To Next Page
Loading...
Need help?
General
