bizhub C3851FS/C3851/C3351 1-13
1.3 Regulation notices
1
Introduction Chapter 1
CDRH regulations
This machine is certified as a Class 1 Laser product under Radiation Performance Standard according to the
Food, Drug and Cosmetic Act of 1990. Compliance is mandatory for Laser products marketed in the United
States and is reported to the Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug
Administration of the U.S. Department of Health and Human Services (DHHS). This means that the device
does not produce hazardous laser radiation.
The label shown on page 1-13indicates compliance with the CDRH regulations and must be attached to laser
products marketed in the United States.
7WARNING
Use of controls, adjustments or performance of procedures other than those specified in this manual
may result in hazardous radiation exposure.
- This is a semiconductor laser. The maximum power of the laser diode is 22 mW and the wavelength is
770-800 nm.
For European users
7WARNING
Use of controls, adjustments or performance of procedures other than those specified in this manual
may result in hazardous radiation exposure.
- This is a semiconductor laser. The maximum power of the laser diode is 22 mW and the wavelength is
770-800 nm.
Laser safety label
A laser safety label is attached to the outside of the machine, as shown below.
Ozone Release
During print operation, a small quantity of ozone is released. This amount is not large enough to harm anyone
adversely.However, be sure the room where the machine is being used has adequate ventilation, especially
if you are printing a high volume of materials, or if the machine is being used continuously over a long period.
To Next Page
Loading...
Need help?
General
