Konica Minolta bizhub C554 User Manual

17
17-18 bizhub C554/C454/C364/C284/C224
[Center Staple Position]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
- [Center Staple Position]
If the staple position is not on the fold line on saddle-stitched paper, use this option to align the staple posi-
tion on the fold.
Copy after configuration, then repeat adjustments as required.
Tips
- This item is available when the Finisher FS-534 and Saddle Stitcher SD-511 are installed.
- This item is available when the Finisher FS-535 and Saddle Stitcher SD-512 are installed (only for
bizhub C554).
- Adjust the half-fold position before adjusting the center staple position.
- Make adjustment while checking paper stapled at a displaced position.
- The value you set by selecting [All] in [Paper Size] will be added to the setting for each paper size.
- For adjustments to put staples parallel with the left edge of paper, contact your service representative
for instructions.
[Horizontal Punch (Z-Fold)
Position Adjustment]
If the positions of the punch holes on the paper are displaced sideways,
use this option to adjust the punch hole positions.
For details, refer to page 17-24.
[1st Z-Fold Position Adjust-
ment]
Use this option to adjust the 1st Z-fold position.
For details, refer to page 17-25.
[2nd Z-Fold Position Ad-
justment]
Use this option to adjust the 2nd Z-fold position.
For details, refer to page 17-25.
[Punch Unit Size Detect
Sensor]
Use this option to adjust the sensor of the Punch function to detect the
edge of the paper.
For details, refer to page 17-26.
[Post Inserter Tray Size Ad-
justment]
If the size of the paper loaded into the post inserter is not detected correct-
ly, use this option to automatically adjust it so that it is detected correctly.
For details, refer to page 17-26.
[Paper Alignment Plate
Settings]
If paper is not discharged with the edges aligned, use this option to adjust
the effective width of the paper alignment plate for making discharged pa-
per stored neatly.
For details, refer to page 17-26.
Settings Description
Settings Description
[Paper Size] Select the size of paper that is used to adjust the staple position.
[Adjust Value] Enter an adjustment value between -10.0 mm and 10.0 mm by tapping [-]
and [+].
• [-]: Move the staple position to the left.
• [+]: Move the staple position to the right.
[0.0 mm] is specified by default.

Konica Minolta bizhub C554 Specifications

General

Print Resolution	1200 x 1200 dpi
Scan Speed	Up to 160 opm
Category	All in One Printer
Functions	Print, Copy, Scan, Fax
Print Technology	Laser
Print Speed (Black)	55 ppm
Print Speed (Color)	55 ppm
Hard Drive	250 GB
Type	Color Multifunction Printer
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Print Speed	55 ppm (black & color)
Paper Capacity	Max 6, 650 sheets
Monthly Duty Cycle	300, 000 pages
Connectivity	Ethernet, USB
Paper Size	A3 to A5, SRA3, custom sizes
Memory	2 GB
Fax Resolution	200 x 200 dpi
Display	9-inch color touchscreen