Konica Minolta BIZHUB PRO C6500 User Guide

Before Making Copies
8
bizhub PRO C6500 8-19
8.5 Setting Job During Warmup
While the machine is warming up after power is turned on, you can select
copy conditions and start scanning so that the machine may start printing
immediately the machine engine is ready.
Service can set the machine to disable this function. Contact your service
representative, if desired.
To scan the original during warmup
1 Turn on the main power switch and sub power switch of the machine.
– For details on turning on the power, see page 2-22.
2 Display the Copy Screen to check that the message “Ready to set re-
serve job” is displayed in the message area.
– A few seconds after the Wake-up Screen appears on the touch
panel, the Machine Status Screen with four types of warm-up im-
age will be displayed in succession.
Touch [COPY] tab to change the Machine Status Screen to display
the Copy Screen, then check that the message “Ready to set re-
serve job” is displayed in the message area.
3 Set the desired copy conditions, and enter the print quantity.
– For details on setting print quantity, see page 8-17.
4 Position the original FACE UP in the ADF or FACE DOWN on the orig-
inal glass.
– For details on positioning the original, see page 8-12.
5 Press [Start].
C6500USv1.book Page 19 Monday, September 11, 2006 1:51 PM

Konica Minolta BIZHUB PRO C6500 Specifications

General

Monthly Duty Cycle	300, 000 pages
Duplex Printing	Yes
Scanner Type	Color Scanner
Scanner Resolution	600 x 600 dpi
Copy Resolution	600 x 600 dpi
Print Speed	65 ppm (color and B&W)
Resolution	1200 x 1200 dpi
Connectivity	Ethernet, USB
Operating System Compatibility	Mac
Color Capability	Full color
Copy Speed	65 ppm (color and B&W)