Pass the tip of the strap through the camera’s
strap eyelet from below and then the holder
ring (1). Attach the strap so the tip comes
between the strap and the camera.
Thread the tip of the strap through the inside of the buckle and pull
to tighten (2). Leave some slack in the camera strap so the tip may
be threaded through the buckle easily.
Push the holder ring toward the strap eyelet to secure the strap to
the camera (3). Repeat with the other end of the camera strap.
12 G
ETTING STARTED
GETTING STARTED
ATTACHING THE STRAP
With the visible protrusions on the
inside of the holder ring oriented as
shown, pass the tip of the strap
through the ring.
123
To Next Page
Loading...
Need help?
General
