1
WARNING
(Failure to adhere to the following points may result in death or serious
injury.)
Do not use the instrument in places
where flammable or combustible
gases (gasoline fumes etc.) are
present. Doing so may cause a fire.
Do not disassemble or modify the
instrument or the AC adapter. Doing so
may cause a fire or electric shock.
Always use the AC adapter supplied as
a optional accessory, and connect it to
an AC outlet of the rated voltage and
frequency. Using a non-specified AC
adapter or connecting it to an incorrect AC
outlet may damage the instrument or AC
adapter, causing a fire or electric shock.
The instrument should not be operated if
it is damaged or AC adapter is damaged,
or if smoke or odd smells occur.
Doing so may result in a fire. In
such situations, turn the power OFF
immediately, remove the batteries (or
disconnect the AC adapter from the AC
outlet), and contact the nearest Konica
Minolta-authorized service facility.
If the instrument will not be used for a long
time, disconnect the AC adapter from the
AC outlet. Accumulated dirt or water on the
prongs of the AC power cord’s plug may
cause a fire and should be removed.
Do not put the batteries on a fire,
charge them (if they are not chargeable),
short-circuit them, heat them or disassemble
them. Doing so may cause an explosion or
heat generation, resulting in fire or injury.
Take special care not to allow liquid or metal
objects to enter the instrument. Doing so
may cause a fire or electric shock. Should
liquid or metal objects enter the instrument,
turn the power OFF immediately, remove
the batteries (or disconnect the AC adapter
from the AC outlet), and contact the nearest
Konica Minolta-authorized service facility.
Should liquid leak from batteries and contact
to eye, wash liquid off with clean water without
rubbing eyes and immediately seek for
medical professional’s advice. In case liquid
contacts with hand or clothes, wipe it off with
plenty of water. Avoid further use of such unit.
Do not forcibly bend, twist or pull the
power cord. Do not place heavy objects
on, or damage or modify the power
cord. Doing so may damage the power
cord and cause fire or electric shock.
Dispose of batteries used in the instrument
correctly. Disposing of batteries incorrectly
may result in heat generation or cause
batteries to catch fire due to short circuiting.
This may result in a fire, injury, or burns.
Disposal methods for batteries may vary
according to where you live. Dispose of
batteries in accordance with local regulations
or through a registered waste disposal agency.
Always disconnect the power cord by
holding the power plug. Pulling the power
cord itself may damage it and cause fire or
electric shock. Do not insert or disconnect
the power cord plug with wet hands.
Doing so may cause electric shock.
Insert the power plug fully and securely.
ncomplete inserting may cause
fire or electric shock.
Do not touch or hold the batteries
with wet hands. Doing so may
cause electric shock or failure.
WARNING
(Falling to adhere to the following points may result in injury or damage to
the instrument or other property.)
Do not use batteries other than those specified by KONICA MINOLTA. When installing batteries in
the instrument, make sure that they are correctly oriented according to the (+) and (-) marks. Also
make sure not to mix new and old batteries, or mix batteries of different types. Failure to adhere to
these instructions may cause batteries to explode or leakage of electrolyte, resulting in fire, injury or
air pollution.
The socket-outlet shall be installed
near the machine and shall be easily
accessible.
When cleaning, disconnect the power
plug. Connecting may cause electric
shock.
SAFETY PRECAUTIONS
To ensure correct use of this instrument, read the following points carefully and adhere to them. After you
have read this manual, keep it in a safe place where it can be referred to anytime a question arises.
To Next Page
Loading...
Need help?
General
