Konica Minolta T-10A - Initiating Automatic Stop Measurement

21
Σ lx·h → Integrated illuminance (lx·h)
Σ h
Σ AVG lx → Integration time (h)
Automatic Integration Stop Function
The instrument has a function that stops measurement automatically when the preset integration
time or integrated illuminance is reached during measurement of integrated illuminance.
z
It is not possible to preset both integration time and integrated illuminance at the same time. The
integration time or integrated illuminance, whichever is set last, will be effective.
Setting Method
1
Set the power switch to “O” (OFF) and push in the hold
button (HOLD).
2
Set the power switch to “I” (ON).

“0 lx” will appear in the display section.
3
Press the [
Σ
] key to switch the mode and make sure that “0.00
lx·h” is displayed (or “0.000 h” in the case of integration time
display mode).

The measurement unit will switch as shown below.
▲Displays the integrated illuminance.
▲Displays the integration time.