Korg D1 - Keyboard Stand Installation; Attaching the ST-SV1 Stand

17
TheD1canbeusedwithanST-SV1keyboardstand(the
ST-SV1BKmodel,soldseparately).FortheD1,usethe
instructionsshownbelowinsteadforstep8whenassem-
blingtheST-SV1BK.
Using two people, lift the D1 (A), and attach it to the ST-
SV1stand(B).
While one person prevents the D1 from falling down, The
other person lines up the screws (o) on the left and right
oftheST-SV1withthescrewholes(n)ontheboomofthe
D1. As a guide, the plate (f) should fit right between the
twogrooves(p)onthecenteroftheboomoftheD1.Be
careful that the plate does not touch the screw (k) at center
frontoftheboomoftheD1andtheheadofthescrew(l)
in the center towards the back.
Align the holes (n) under the D1 to match the screws (o) of
theST-SV1.
Remove the included AC adapter before assembling
theST-SV1.
 Beverycarefulnottopinchyourngersduringlifting
andaachingtheD1totheST-SV1.
 MakesurethattheD1isrmlysecuredtotheST-SV1
beforeplaying.FailuretosecuretheST-SV1maycause
theD1tofalloandinjureyou,orcausedamageto
the D1.
When using the ST-SV1 optional keyboard
stand (sold separately)
1 2