81
P2 Bounce: Settings for bounce
recording
For the procedure of bounce recording, refer to p.29.
1. Select BounceMode .......... [14Tr+2In→2Tr, 16Tr→2Tr]
Select the type of bounce recording.
14Tr+2In→2Tr: Select this when recording 14 tracks
of playback + 2 inputs onto two tracks.
The input sound selected in the [INPUT] “Ch1–8”
tab page and “Ch9–16” tab page will be valid for the
channel(s) whose [TRACK STATUS] key is set to
REC (LED lit red), and will be recorded together
with the other playback tracks.
16Tr→2Tr: Select this when recording 16 tracks of
playback onto two tracks.
The track playback will be valid for the channel(s)
whose [TRACK STATUS] key is set to REC (LED lit
red), and will be recorded together with the other
playback tracks.
Be aware that if “Rhythm” is set to “On” during
bounce recording, the rhythm will also be recorded
together with the other sounds (→p.61).
2. RecordVirtualTrack............................ [Current, a…h]
Select the recording destination virtual track.
Select the virtual track of the recording track
selected by the [TRACK STATUS] key on which
bounce recording will occur.
By selecting a virtual track “a”–“h” other than
“Current,” you can combine tracks 1–16 into two
tracks without erasing any of the tracks 1–16.
Current: The currently selected track
a…h: The specified virtual track
However if the same virtual track is selected both
here and for [TRACK] “Vtr1–8” or “Vtr9–16” tab
page the result will be the same as if “Current” were
selected.
To avoid accidentally recording a track that has
already been recorded, use the [TRACK] “Vtr1–
8” and “Vtr9–16” tab pages to see which virtual
tracks are currently selected and which contain
data.
P1 Vtr1–8:
Select virtual tracks 1–8
1. Select VirtualTrack................... [1a…1h, …, 8a…8h]
Select the virtual track for each track “1”–“8.”
Each track has eight virtual tracks: “a”–“h.” One of
these virtual tracks can be selected for recording/
playback.
2. SelectAll .................................................... [On, Off]
Turn this “On” if you wish to use the same virtual
track number for all tracks (1–16). Then choose any
“Select V
irtualTrack” to choose the track.
On: All tracks will be set to the same vir-
tual track number.
Off: The virtual track number can be
selected independently for each track.
P2 Vtr9–16: Select virtual tracks
9–16
For details refer to “Vtr1–8.”
This page cannot be selected for a 24 bit song.
1. Select VirtualTrack............... [9a…9h, …, 16a…16h]
Select the virtual track for each pair of tracks.
2. SelectAll .................................................... [On, Off]
P3 EditTrk: Track editing
Editing will apply to currently selected tracks 1–16
(→”Vtr1–8,” “Vtr9–16”). Virtual tracks that are not
selected will not be affected by editing. (However,
“CopyWholeTrack” and “SwapWholeTrack” are
exceptions.)
1
2
4. TRACK
2
1
Recorded track
Selected track
1 6
5
2
3
4
Reference
RECORDTRACK
To Next Page
Loading...
Need help?
General
