90
3. DestSong .................................[(I, A...G/001...100)]
This displays the move destination drive, and lets
you select the song number.
You can select song numbers “001”–“existing song
numbers”.
4. Exec. (Execute) ........................................................
Execute the move operation.
If the selected move destination number (“Dest-
Song”) is higher than the move source number
(“Sour
ceSong”), executing this operation will cause
the “DestSong
” and the preceding song numbers to
be renumbered downward by one. If the move des-
tination number is lower than the move source
number, the “DestSong
” and following song num-
bers will be renumbered upward by one. No songs
will be overwritten.
Undo is not available for this operation.
EditType: “DeleteSong”
The currently selected song will be deleted.
2. DestSong .................................[(I, A...G/001...100)]
This displays the drive, song number, and name of
the song that will be deleted. If you wish to change
this, use the [SONG] “SelSong” tab page to make
your selection.
3. Exec. (Execute) ........................................................
Execute the delete operation.
When you execute, the “DestSong
” song will be
deleted, and subsequent songs will be renumbered
downward by one.
Undo is not available for this operation.
EditType: “ProtectSong”
The currently selected song will be protected, so that
writing, and deletion are prohibited. This lets you pre-
vent a completed song from accidentally being over-
written and deletion.
No writing and delete operations can be performed
when protect is on, including recording, track edit-
ing, and registering a scene.
When protect is turned on, the settings of a song
will also be stored. Fader and EQ etc. will reflect
your editing, but will not be stored.
2. DestSong .................................[(I, A...G/001...100)]
This displays the drive, song number, and name of
the song that will be protected. If you wish to
change this, use the [SONG] “SelSong” tab page to
make your selection.
3. Exec. (Execute) ........................................................
Execute the protect operation.
Each time you execute, protect will be turned on or
off.
Undo is not available for this operation.
4. Protect On/Off Mark ..................................[On, Off]
A “lock” symbol will be displayed when protect is
On, and will be hidden when protect is Off. The
on/off setting is switched by the “Exec.” button.
EditType: “CopyAllSongs”
All songs of the drive where the currently selected song
is located will be copied.
2. SourceDrive ............................................... (I, A...G)
This displays the copy source drive.
3. DestDrive ................................................. [(I, A...G)]
This displays the copy destination drive.
Use “Drive” to select the drive.
4. Drive..........................................................[I, A…G]
Select the copy destination drive.
When you press this button, a dialog box will
appear. Select the drive, and press the “OK” button.
5. Exec. (Execute) ........................................................
Execute the copy operation.
When you execute this command, the songs will be
copied following the last song on the copy destina-
tion drive (“DestSong”). No songs will be overwrit-
ten.
Undo is not available for this operation.
P3 PrgPlay: Program playback of
songs
You can create a program play list to arrange songs in a
desired order, and play them consecutively.
For settings and playback procedure, refer to p.33.
1. Select TimeDisp Type...............[Abs–Song, Abs–Total]
Select the type of counter display.
1
3
2
1
3
4 2
1
5
2 3
4
2
1
3
To Next Page
Loading...
