139
The system software of the D1600 can be updated from
an external SCSI disk that contains D1600 system files.
For details on system file, please contact Korg distribu-
tor.
Connections
Connect the external removable disk drive containing
the system file to the D1600 via SCSI. (→p.67)
Be sure to turn off the power of both devices before
you make connections.
Updating the system
1 Select the drive connected to the D1600.
In the [SYSTEM] “DiskUtil” tab page, use “Drive
ID” to select the drive that contains the system file.
It is also possible to update the system from the
internal CD-R/RW drive.
2 Use “SelOperation” to select “LoadSystem.”
3 Execute the load operation.
Press the “Exec.” button. When the display asks
“AreYouSure?” press the “Yes” button to begin
loading.
If the power is turned off accidentally while the
system is being loaded, the D1600 may become
incapable of operating correctly. If this occurs,
please contact your Korg distributor.
4 When loading is completed, the following dis-
play will appear, and the loaded system will be
checked.
If the check sum result is correct, the display will
indicate “Check sum=OK.” If not, the display will
indicate “Check sum=NG.”
In the case of “OK,” the D1600 will automatically
restart after a while, and will begin operating with
the new system.
In the case of “NG,” restart the D1600, and attempt
the loading procedure once again.
If the display still indicates “NG,” please contact
your Korg distributor.
Updating the system software
Appendices
Updating the system software
To Next Page
Loading...
