100
3a. INPUT/OUTPUT/CH ASSIGN
3a-1. Channel Assign
Here you can specify the input for each mixer channel 1–32
[*16].
When you select a digital input such as S/P DIF or ADAT, noise
may occur if the digital data is not synchronized. You should turn
down these faders or turn down the volume of your monitor sys-
tem before you change these settings.
1. CH1…32 [*16] [1…16, CD L, CD R, L, R,
Rhythm L, R, A1…8]
The number of assignable channels will depend on the sam-
pling rate and bit depth of the current song (→p.136).
You can select the input sources 9…16 or ADAT 1…8 only if
the 8-channel analog input board or the ADAT I/O board op-
tions are installed respectively.
Select a channel icon “CH1”–“CH32 [*16],” and then
select the source that will be input to this channel.
INPUT 1…16: …
The analog signal from an instrument etc. connected
to the INPUT 1/GUITAR IN–INPUT 16 jacks will be
input to the mixer channel.
CD L, R: ,
The audio track of audio CD inserted in the internal
CD-R/RW drive will be input to the mixer channel.
You can select this if “Source Select CD or S/P DIF” is
set to “CD.”
S/F DIF L, R: ,
The digital signal from a device (e.g., DAT) connected
to the S/P DIF IN jack will be input to the mixer chan-
nel.
You can select this if “Source Select CD or S/P DIF” is
set to “S/P DIF.”
Rhythm L, R: ,
The rhythm selected by “Rhythm Pattern” will be
input to the mixer channel. If the “Rhythm,” “Assign”
is set to “CH Input” and the Rhythm On button is on,
the rhythm will sound. You can record this rhythm.
(→p.133)
A1…A8: ...
The signal from an external ADAT device connected to
the ADAT connector will be input to the mixer chan-
nel.
You cannot assign ADAT input if the current song is 96 kHz/
24-bit.
2. Source Select CD or S/P DIF
Press the Select button to display the Source Select dia-
log box.
Here you can select either “CD” or “S/P DIF” as the dig-
ital INPUT source.
A message of “Obey Copyright Rules” will appear.
Carefully read the section “COPYRIGHT WARNING”
(→p.iii) in the manual, and press the OK button if you
accept the terms. Digital input will be enabled.
If selecting “S/P DIF” causes a message of “Audio Sync
Error” to appear, and/or there is something wrong with
the sound, add a check mark to the “Change Sync source
S/P DIF” check box.
If “Audio Sync Error” appears even when “Change Sync
source S/P DIF” is checked, verify that in the SYSTEM,
“Word Clock” tab page, the “Word Clock” frequency is the
same as the sampling frequency of the current song.
If “Change Sync source S/P DIF” is checked, the D32XD/
D16XD will stop operating if synchronization is interrupted
during recording/playback or if the synchronization frequency
changes. If the D32XD/D16XD stops operating due to a syn-
chronization problem during recording, please format that
song drive.
3. buttons
Use these up/down buttons to select the INPUT source.
1
2
3
1
2
3
D32XD
D16XD
To Next Page
Loading...
Need help?
General
