47
Operation
Song,
Locate
MixerEffects
RhythmRecorder
CDDataDriveUSBMIDIUpgrading
the system
Touch Panel
Calibration
Alternatively, you can press the popup button beside the
cell to display the Select Comp Program dialog box, and
make your selection there.
(5) Recall the comp program.
Press the Yes button to recall the program.
If you decide not to recall, press the No button.
2. Audio outputs from the mixer
MASTER OUT L, R
These outputs provide the audio signals from the master bus.
Use the MASTER fader to adjust the volume of the MASTER
OUT jacks and the level of the signal being recorded on the
master track.
MONITOR OUT L, R
Refer to “3-7. Monitor settings” (→p.50).
AUX OUT 1, 2, 3, 4 [*1, 2]
Refer to “3e-3. Aux1 Send” (→p.112).
ADAT OUT
You can select the channels or tracks that will be output to an
ADAT device.
The optional ADAT I/O board must be installed (→p.178).
ADAT output is not possible if the current song is 96 kHz/24-bit.
(1) Connect the cable to the ADAT OUT jack.
(2) Access the MIXER, INPUT/OUTPUT/CH ASSIGN
,
“ADAT.Out” tab page.
(3) Select the channels or tracks that you want to output to
ADAT Out 1–8.
CH1–8, CH9–16, CH17–24, CH25–32 [*CH1–8, CH9–16]
The signals of CH1–8, CH9–16, CH17–24, or CH25–32
[*CH1–8 or CH9–16] will be output.
The sound with EQ and effects applied will be output
during playback or recording.
Track 1–8, Track 9–16, Track 17–24, Track 25–32
[*Track 1–8, Track 9–16]
The playback of tracks 1–8, tracks 9–16, tracks 17–24, or
tracks 25–32 [*tracks 1–8 or tracks 9–16] will be output.
The sound without EQ or effects will be output during
playback.
S/P DIF OUT
This jack sends a digital audio version of the same audio sig-
nal as the MASTER OUT L/R jacks, at the same sampling fre-
quency and bit depth as the current song.
D16XD
D32XD
Mixer
To Next Page
Loading...
Need help?
General
