* If you press Y E S then you can continue from
step(2) above and save other waveforms*
7; P re s s Y E S to c o n tin u e o r p re s s N O to quit*
Press
• Pressing Y E S takes you back to where the DSS-1 is
standing by for waveform select. Continue from step
above.
★ If you press NO then you leave the save
waveform function and are prompted to select a
function.
NO
Press
• This ends the save waveform function and returns
you to the function select.
(If you had saved the waveform before quitting,
then the display says “Saved“.)
(If you had aborted befor quitting, then the
display says “Aborted1'*)
• If you press Y E S in step (6), then DSS-1 first checks
the disk directory to see if the name that you entered
already exists. If it finds a waveform of the same
name, then it sks you whether it is okay to delete that
sound or not. refer to F5 SA V E SA M P L E (in the sam
ple mode) for details on this procedure.
CREATE WAVEFORM MODE
To Next Page
Loading...
