EDIT SAMPLE MODE
F3 TRUNCATE START/LEN6TH
i Purpose of truncate start/length function.
■ This lets you cut off a piece of a sound that you have
loaded into the work area (using F1). You specify the
starting point and the length of the section to be cut
out. Afterward, you can use the F8 SAVE/RENAM E
SA M P LE function to save the truncated sector to
disk. This is handy for cutting samples down to
smaller sizes.
EDIT WORK AREA
* - 1—
SOUND SOUND
START LENGTH
■ About the Auto Truncate capability.
This is effective when editing the S S (sound start)
and SL (sound length) parameters.
While editing SS, if you press the EN TER key, then
the S S point will move inward to (]) in the example.
Press EN TER again and it will move to ¡2>. Similarly,
while editing SL. if you press the EN TER key, the SL
will shorten to point LIT in the example. Press ENTER
again and it will shorten again to point \2 ]. In other
words, auto truncate shortens the sound white cut
ting at the zero cross point.
Direction of automatic truncation
S.S
■ Using the DATA ENTRY A and B sliders and arrow
keys to enter numeric values.
These cover six places. The DATA EN TRY A slider
covers the 10,000 And 100,000 places. The DATA
ENTRY A keys handle the thousands place. The
DATA ENTRY B slider covers the hundreds and tens,
while the keys handle the ones.
DATA ENTRY A
DATA ENTRY B
116
To Next Page
Loading...
