Korg DSS-1 - Page 206

PROGRAM PARAMETER MODE
2 U s e D A T A E N T R Y B to s e le c t a m u ltrso u n d.
DATA ENTHY B
W Ï 1 A
T
Use to select
multisound
• You can now select a multisound.
i
ENTER
\ V é .
Shows the multisound selection.
Flashes.
• The EN TER key normally flashes at this point. But if
the displayed multisound has already been selected
then the ENTER key does not flash.
3; Press EN TER to go ahead.
ENTER
Press : " c
after the
confirmation
* The displayed multisound is registered and the
EN TER key stops flashing.
2061