Korg DSS-1 - Page 207

Fl3 OSC 2 MULTI SOUND
1 Oscillator-2 multisound function.
■ Used to select the multisound for oscillator 2.
2 'Using the oscillator-2 multisound function.
■ Refer to instructions for oscilltor-1 multisound func
tion operation.
F14 MIX RATIO
1 i The mix ratio function.
■ Adjusts volume balance between oscillator-1 and
oscillator-2.
2 Using the mix ratio function.
■ Press 1 then 4, or use DATA EN TRY A to select the
MIX RATIO function.
■ Use DATA EN TRY B to adjust the value.
F15 OSC 2 DETUNE & INTERVAL i
i The oscillator 2 detune & interval function
■ Used to change the pitch of oscillator-2 relative to
oscillatoM.
• Detune:
Detuning raises the pitch of oscillator-2 very slightly
so that it beats with oscillator-1, thereby making a
fatter sound or chorus-like effect.
O S C I
OSC 2
Possible mix ratio values
I 00% -b0%-~ 0%
1 ; 4 "i""
: 0 % -so% -Ioo%
I
I
Mix ratio display.
Values for oscillator 1 and 2 are shown.
I Possible detune values
I
0 0 -6 3
I
i
...... J
• Interval:
Here we set oscillator-2 at a note higher than oscillator-
1, so that the difference in pitch produces an interval.
Note that this shifts the whole keyboard range up,
much like the effect of the F11 O S C OCT function.
While the oscillator octave function shifts the
keyboard range in octave steps, the interval function
shifts it In semi-tone steps.
Possible interval values 1
0 0 -M
207'
PROGRAM PARAMETER MODE