Korg DSS-1 - Page 209

F17 OSC MG MOD
11 Oscillator modulation mode function.
■ This function controls modulation of the oscillator fre
quency, producing various vibrato effects (regular
pitch fluctuations).
Four parameters are covered, as follows:
• Modulation mode:
Offers four options of which oscillators, if any, are to
be affected.
• Frequency:
Controls the speed of the vibrato (by adjusting the
modulating signal frequency).
• Intensity:
Controls the depth of modulation, that is, the amount
of pitch fluctuation in the vibrato effect.
• Delay:
Lets you delay the onset of the vibrato effect after you
play a note.
Possible modulation mode settings
OFF. OSC I. OSC 2, BOTH
Possible frequency values
00 3 1
Possible intensity values
0 0 - I 5
Possible delay values
00 • lb
Piteli
i_2j Using the oscillator modulation mode function.
■ Press 1 then 7, or use DATA EN T RY A to select the
O SC MG M O D function.
■ Use the cursor keys to select parameters. Then use
DATA ENTRY B to adjust the values.
Display for oscillator modulation mode function.
Shows modulation mode.
1 r
i
F*I f
■ P + M M M l
L.» ï
OSC MGMÜD: BOTH
Ì8 INT=02 DLV-05
Shows frequency.
J L
Shows intensity.
ï
Shows delay.
T
209
PROGRAM PARAMETER MODE