Korg DSS-1 - Page 214

PROGRAM PARAMETER MODE
2 Using the VCF mode & EG polarity function.
■ Press 3 then 1 * or use DATA EN TR Y A to select the
VC F M ODE & EG POL function,
■ Move the cursor to the parameter thay you wish to
change. Then use DATA EN TR Y B to adjust its value.
F32 VCF CUTOFF & EG INT
Display for VCF mode & intensity function.
VCF mode setting. EG polarity setting
U The VCF cutoff & EG intensity function.
■ Lets you adjust the filter cutoff frequency and the in
tensity of modulation by the envelope generator,
• VCF cutoff:
Sets the cutoff frequency of the low pass filter. This
kind of filter starts to attenuate frequencies above the
cutoff. The higher the value, the brighter the sound.
At 127, no harmonics are removed, so there is no ef
fect on the timbre. The lower the value, the more har
monics are removed, so the duller or more mellow the
sound’s tone color.
• EG Intensity:
This parameter determines the intensity of envelope
generator (VCF EG) modulation of the VCF cutoff fre
quency, When you pfay a note, the cutoff frequency
changes according to the VC F EG envelope settings.
Possible VCF cutoff frequencies,
000- I 21
Level
Cutoff frequency
t
000
Value
-►127
Frequency
Possible EG Intensity values
00-63
VCF cutoff frequency
parameter setting.
(This example is for positive (+ ) EQ polarity.)
14