Korg DSS-1 - Page 215

2|Using the VCF cutoff & EG intensity function.
■ Press 3 then 2, or use DATA ENTRY A to select the
VC F CU TOFF & EG INT function.
■ Use the cursor keys to select a parameter. Then use
DATA ENTRY B to adjust its value.
F33 VCF RESO & KBD TRACK
J] VCF resonance and keyboard tracking function,
■ Resonance creates a peaky or bandpass type sound
by emphasizing the harmonics near the cutoff fre
quency. Keyboard tracking determines the degree to
which the cutoff frequency changes in proportion to
the pitch of notes played on the keyboard.
• Resonance:
The higher the value of this parameter, the stronger
the resonance peak in the vicinity of the cutoff fre
quency, Near the maximum value of 63, the VCF
goes into self-osciilation, producing a sound that is
audible as separate from the oscillator sound.
• Keyboard tracking:
With keyboard tracking, the sound gets brighter as
you play higher notes, as is the case with most
acoustic instruments. The value of this parameter
determines the degree to which the change in cutoff
frequency is proportional to the change in keyboard
pitch.
Display for VCF cutoff & EG intensity function,
pTy Mf;F
CÜTGFF=@64
EG-IHT=10
Cutoff frequency setting
EQ intensity setting.
Possible resonance values
00-63
Level
Possible keyboard tracking values
00-63
Level
\
\
\
/
/
/
/
/
\
\
\
\
\
\
s
ì
Cutoff frequency
when lowest key
is played.
t
Cutoff frequency
set with F32.
' This range gets
wider with higher
KBD TRACK
values.
Frequency
Cutoff frequency
when highest key
is played.