~S
Damper
■ An optional toot switch such as the PS-1 or DS-1 may
be connected to the rear panel damper jack to serve
as a damper pedal like that on a piano* Depending on
the program, this can also be used to obtain a hold ef
fect (so that a note is held for as long as you press on
the foot switch, even if you release the key on the
keyboard).
[6 Program up
■ You may connect an optional foot switch such as the
PS-1 to the rear panel program up jack. Then each
time you press the foot switch, the program number
(patch number) will advance by one.
r
i
I
\
PS-1
etc.
▼
DAM PER
GND
▼
PROG UP
t— GND
■ Note that after program 32, you loop back around to
program 01 again.
UP
UP
UP
UP
UP
/
\
1
I
/
22