PROGRAM PARAMETER MODE
F52 VCF CUTOFF/MG MOD
Ï The VCF cutoff/MG modulation function.
This lets you use after-touch to sweep the cutoff fre
quency or control cyclic modulation (wah-wah effect)
of the VCF. You can choose either CUTO FF or MG-
MOD.
M G -M O D . C U T 01- I-
Possible mode sellings
• Cutoff:
If you select this mode, then after-touch pressure
causes an upward filter sweep, increasing the
brightness of the sound.
The higher the value, the greater the timbral change.
Possible values
0 0 - fb
I
• MG modulation:
If you select this mode, then after-touch pressure
controls the intensity of the wah-wah effect (cyclic
filter modulation). The higher the value, the greater
the change.
Wah-wah frequency (speed) is determined by the F34
VC F modulation mode function setting.
2!U$ing the VCF cutoff/MG modulation function.
■ Select the function by pressing 5 then 2 on the number
keys or by moving the DATA ENTRY A slider.
M Move the cursor to the parameter that you wish to
change. Then use DATA EN TRY B to select its value.
If mode is set to cutoff.
Level
Display for the VCF cutoff/MG modulation function
F52 UCF AFT TOUCH
MÜDE=MG-~riÜD UHLUE-ìO
Mode selection.
t
Value
2281
To Next Page
Loading...
