iJThe modulation intensity function.
A This controls the intensity of modulation of the DDL-1
and DDL-2 delay times as applied by the two modula-
tion generators (MG-A and MG-B), (Each of the DDLs
can be modulated by both of the MGs.) Raising the
value of MG-A, for instance, means that the delay
time will be modulated more strongly by the MG-A
frequency. The same goes for MG-B. If both are given
values higher than 00 (and if they are set to different
frequencies), then the modulating waveform be
comes quite complex, with corresponding complexity
of the effect produced by the digital delay.
A
.....
00 -6 3
B
..........
00 ■ 63
Possible values for the modulation intensity function.
• Example, using modulation generators A and B set at
different frequencies.
MG-B output waveform.
t
MG-A and MG-B output used together.
237I
PROGRAM PARAMETER MODE
To Next Page
Loading...
