Korg DSS-1 - Page 238

■ Press number keys 8 then 4 (or 9 then 5), or move the Display fur the modulation intensity function
DATA ENTRY A slider to select the function. _____ I ___
.2 Using the modulation intensity function,
f-------------------------------------------------------------------------------------------------------------------------1
1— L - V j l sr t: •««
i * . J ‘T Ì..- L / L .. .
1 A i n i w * H i J » « i
Mu-H =üb
ViG--B =24
L. ________ ______ J l— _______ J
Intensity of MG A Intensity of MG B
■ Move the cursor to the parameter that you wish to
change. Then use the DATA EN TRY B slider to
change the value.
F91 INPUT SIGNAL SELECT
:H About the input signal select function.
■ This gives you a choice of which signal to use as the
input for DDL-2. You may choose either the direct
signal or the DDL-1 output signal. For typical stereo
effects, you would choose to use the direct sound
since this will give you an independent delay for each
of the two outputs,
■ For other effects, you may choose DDL-1 as the in
put, thereby connecting the two delays in series and
modulating the first effect with the second effect.
+
DDL‘2 effect
H"
direct sound)
Possible input signal select function values.
D IR E C T . D D L - 1
The delays may be internally connected as showi
here.
If D IRECT is chosen.
If DDL-1 i$ chosen
+
djrect sound)