SYSTEM MODE
F2 SAVE SYSTEM
1 About the save system function
■ This function is used to save the system in memory to
disk as a system labeled A, B p C P or D.
■ Saving a system having no multisounds is the same
as using the All Program Save function. The display
will show "N o M, SN D s Exist”. The program contents
on disk will change.
WAVE-MEM. PROGRAM-MEM
■ Current MIDI parameters are saved with the system.
|2j Using the save system function.
Operation
Operation of DSS-1
it Select the SY ST E M mode. You must have a
disk in the drive. You will save the system to the
disk that is in the drive. Therefore, don't putina
disk that is full of systems that you want to keep.
• Indicates SY ST E M mode.
SYSTEM
* » '
On
•]) Press the number 2 key,
?
• The display shows the currently selected system.
Shows the save system function.
244
To Next Page
Loading...
