LCD
This liquid crystal
display shows data and
messages from the
DSS-1.
CONTRAST CONTROL
Turn this knob to adjust the LCD
for maximum legibility. If you
can not see anything on the
display, try turning this knob
clockwise.
-■ MODE SELECT KEY/FUNCTION MAP
Use the keys in this section to select the operating
mode. If a key's LED is illuminated then that mode
has been selected. If none of the mode key LEDs are
illuminated, then the DSS-1 is operating in the PLAY
mode. The functions available within each mode are
shown in the function list to the right of each of the
mode keys.
-m 10-KEY PAD
These ten keys, numbered
from 0 to 9, are used to
select program numbers, and
to select tunctions within
particular modes.
ENTER KEY
Used tc input data and to
begin disk access. Also used
tor “Key transpose" in the
play mode.
a CURSOR & YES/NO KEYS
Used to move the cursor (the short
underline that indicates your current
position) in the LCD readout and to
respond to messages from the
DSS-1.
5
To Next Page
Loading...
