GENERAL OPERATION
• Parameters of Multisounds Produced in the
Create Waveform Mode
Multisound name: ! NO-NAME
Multisound length: 1020 LO O P ON
Sound
number
SOI S02
soa
SÜ4
S05
506 SQ7
SC8
Relative
tune
+ 09
f 10
i - ! 1 4 12
1 13
' [4 +■15 1 16
Relative
level
64 64
64
64
64 64
64 64
Relative
Fc
64
64
64 64
64
64
64 64
Sound
start
0 0
0 0
0 0
0 0
Sound
length
612
256
128 64
32
16
3 4
Loop
start
0 0
0
0
0 0
0 0
Loop
length
512
256
128 64
32
16
8 4
Original
Key
Rl 82
□3 B4
85 B6
B7
86
Top hey F2
F3
F 4 Fij
F6 F 7
re
F 13
(SQ1 is the waveform data created first.)
[3l Edit Sample Mode
■ The functions of the edit sample mode
This mode lets you edit a waveform obtained in the
sample mode or create waveform mode.
There are two ways to select the sample to be edited.
1 ) From among the multisounds in wave memory,
choose the one that contains the sound that you
want. Then specify the sound number of the par-
ticuiar sound that you want.
2) Choose a sound from among those that have been
saved to disk. Load your disired sound from disk to
memory.
In either case, wave memory is used as the editing
work area and you edit only the single selected
sound. As a result, a multisound is produced that is
made up of just this one sound, and this multisound
appears in the system.
★ When you select a single sound, all other data in
wave memory is destroyed. Be sure to save (to disk)
needed data before entering this mode.
* You will note that in the link and mix functions you
need a second sound. This second sound is obtained
from among the sounds that have been saved to disk.
■ Only a single multisound is produced in the create
waveform mode. For this purpose wave memory is
used as the work area, so ail previous resident data is
destroyed. Before entering this mode, be sure to save
any required data to disk as a sound or multisound.
* This means, for instance, that if you perform har
monic synthesis after hand drawing, the drawn
waveform disappears.
Ji In this mode you can choose one of the eight
waveforms, give it a name as a sound, and save it to
disk.
*■ To save data as a multisound, first switch to the multi
sound mode, then save the data to disk.
• Initial display for edit sample mode.
★ You can select only Ft or F2 immediately upon enter
ing the edit sample mode. F3 through F8 are selec
table after completion of Ft.
■ The following kinds of editing can be performed in
this mode:
• Truncate
• Reverse
• Link
• Mix
• View/edit sample data (Sound data word value
adjustment)
■ An edited sound can be given a name in this mode
and saved to disk.
* To save to disk as a multisound, first switch to the
multisound mode*
56
To Next Page
Loading...
