Korg DSS-1 - Page 68

SAMPLE MODE
■ After the memory division has been selected and the
memory blocks have been made, all the blocks must
be assigned to the keyboard.
This can be done automatically or manually. With the
"Autoassign’1 method, the DSS-1 assigns each
block to a particular predetermined key. With the
"manual assign method, you decide the key to
which to assign each of the blocks.
II you fail to perform sampling for an assigned memory
block, then when you play the keyboard you will hear the
previous sound from wave memory over the length of
that block. When this occures it is usually misinterpreted
as a malfunction.
* Auto-assign.
* Manual assign.
■ The auto-assign method results in the assignments
shown in this chart.
Auto-Assign (Each memory block's "TFVMT,r Is set to TR )
DIV.
SAMPLE HO.
01 02
03
04 05
06 07
08 09 10
11 12
13 14
15
16
01
ORG
C3
TOP
F3
>-
02
ORG
C3 C5
TOP
F3
F5
r
>
04
ORG
C3 C4
C5 C6
TOP
F3 F4
F5 F6
>
>
>
*
>i
08
ORG
C3 F # 3
C4
F #4 C5
F # 5
C6
F # 6
TOP
E3
A # 3
E4 A #4
E5
A #5 E6
A #6
*• -
>
r r
-
>
> r s
-
••i
16
ORG
C3
D # 3
F # 3 A3 C4
D #4 F # 4
A4
C5 D it5
F 35
A5
CG D #6
F 3 6 AG
TOP
D3
F3
G #3 B3 D4
F4
G #4
B4
D5 F5
G 35 B5
DG F6
G 36 B6
■ In the manual mode, you assign the blocks beginning
with the smaller sample number, assigning them
from the low notes upward.
B. Sample number setting
■ From among the memory blocks (created by the
memory division setting) select the sample number of
the block that will be used for FO SA M P L E START
and F4 ORIGINAL/TOP KEY.
NOTE:
With "manual assign” as well, the situation is dif
ferent from the "ordinary key assign" in that you
can not change the TR/NT. (It is fixed at TR.)
{Example: Memory division at 8.)
SMPL KO.
01 02
03 04
05 06
07
08
B
V / iV Î w / A J
W M m
Select memory block tor FO SAM PLE START
and F4 ORIGINAL/TOP KEY.
68