Data in the current harmonics table is normally pre
served even when you finish with the harmonic syn
thesis function. There are two exceptions.
1) If you use the draw waveform function to draw a
waveform. (The current harmonics table data is
destroyed.)
2) If you use the harmonic synthesis function to
select another harmonics table (1 - 6 ), {The new
data will overwrite the previous data.)
■ Besides the above-mentioned choice of six har
monics tables, you can also choose “Current”*
Choosing the “current” option lets you use the cur
rent harmonices table data as is.
2] Using the harmonic synthesis function.
Operation
,P} Confirm that you are in the C R EA T E W AVE
FO RM mode* Check to see that the CREATE
W AVEFORM key’s LED indicator is illuminated*
Press the number 2 key to select the harmonic
synthesis function.
Press
Operation of DSS-1
Indicates CREATE W AVEFORM mode.
C N C A f f - W A V F - F O H W
si t
On
The display confirms your choice of function and
prompts you to select a harmonic table.
Shows the harmonic synthesis function.
F2 HARMONIC SYNTH
Se1eoi Harn s Current
EN TER
S I *
L
Flashes awaiting your choice.
CREATE WAVEFORM MODE
To Next Page
Loading...
