Korg EX-800 Owner's Manual

You may now select any of the VCF parameters by press
ing one of the Number buttons. For example, press ‘ 3 ’ to
select KBD TRACK, ‘ S ’ to select EG I NT, and so on. You
may also press ‘ g ’ to select the Chorus ON/OFF Parameter.
(Pressing ‘ 7 ’ will result in a blank VALUE Display.)
Press BANK HOLD again to cancel the Bank Hold function
and return to the normal two-digit selection method.
MEMORY |
To make any edited or newly created sound PERMANENT, you
must write it into one of the 64 Program Numbers in the memory
( !! - 88 )■
Sound data stored in memory is protected by a back-up bat
tery circuit so it will not be erased even if power is disconnect
ed from the EX-800.
NOTE:
You can only WRITE the currently selected sound to memory.
If you have already reselected the original version, the edited
version is lost.
MEMORY WRITE PROCEDURE
1. Set the Program Write switch on the rear panel to the ENA
BLE position.
-WRITE --------- 1
r~
SEQUENCER
ENABLE DISABLE
x :
PROGRAM
ENABLE DISABLE
J __ LI
EXAMPLE:
To store the edited sound in Program Number 3'-!, press
the Number Select buttons 3 and then . After but
ton ‘ 3 ’ is pressed, the DISPLAY will show the fol
lowing:
■ is displyed unitl the next digit
is entered (Waiting for input)
PROGRAM
NOTE:
A t this point (before the second button is pressed), the “old”
sound in memory is still unchanged. If you pressed the wrong
number for the first digit (AND ARE ABOUT TO ERASE
THE WRONG PROGRAM):
• Switch the rear panel Program Write switch to the DISA
BLE position.
• switch it back to the ENABLE position
• press WRITE button again
• then press the correct Number buttons (‘ 3 ’ and then
■ ')
PROGRAM
The edited sound is now stored in Program Number 3V.
2. Make a mental note of the current Program Number, if you
want to write an edited version “over” the original program.
3. Press the WRITE button. The Program Number in the Dis
play will be relaced by a pair of flashing lines, to show that
you are in Write mode.
Blinks
— WRITE
Switch push
WRITE
4 . Press the Number buttons to select the Program Number
where you want to store the edited sound.
5. Set the rear panel Program Write switch to the DISABLE
position.
i -------- WRITE ---------- 1
SEQUENCER PROGRAM
ENABLE DISABLE ENABLE DISABLE
NOTE:
Protecting Memory
After WRITING a program to memory, it’s a good idea to
always set the Program Write switch to DISABLE. This pre
vents accidental erasure or change of your programs (and,
of course, doesn’t interfere with selecting programs at all).
24

Korg EX-800 Specifications

General

Brand	Korg
Model	EX-800
Category	Synthesizer
Language	English