Korg HT-10 - Page 7

7
Youcanapplyeectstoeachpresetsound.Whenyouturnonthepowertotheunit,
theeectswillusetheoptimumseingsforeachpresetsound.
Transpose function (Shifting the key)
Insomecases,asongmaybewrieninadicultkey(e.g.,usingmanyblackkeys),or
youmaywishtoshithekeytomatchanotherinstrumentorvocalist.Insuchcases,
youcantranspose(shithekey)touseaneasierngering(withoutplayingtoomany
black keys), or to use the same familiar fingering to play in a different key. This is
calledtheTransposefunction.Youcanshithekeyinarangeofelevensemitones.
Forexampleifyoutransposeupwardbyonesemitone,playingthenotesshowninthe
upperscoretothelewillproducethepitchesshowninthelowerscore.
• Totransposethekey,pressandholddowntheA
#
7, B7, and C8 keys, and press a
key from F
#
2toB3orfromC
#
3toF3.Thenameofthekeythatyoupressedwillbe-
comethetransposedkey.Forexample,ifyouwishtousetheC3keytoplaynote
A2 (lower by three semitones), press and hold down the A
#
7, B7, and C8 keys, and
presstheA2key.IfyouwishtousetheC3keytoplaynoteD
#
3(higherbythree
semitones), press and hold down the A
#
7, B7, and C8 keys, and press the D
#
3key.
ToresettheTransposefunctionto“NoTransposition(+/-0),”pressandholddownthe
A
#
7,B7,andC8keys,andpresstheC3key.
Thedefaultseing(whenyouturnontheunit)is“NoTransposition.”
Pitch Control function (Tuning)
Here’showtomakeneadjustmentstothepitch.
Whenyou’replayingtogetherwithotherinstruments,youcanusethismethodtox
anyslightdierencesinpitchbetweeninstruments.
YoucanadjustthetuningoftheHT-10inhalf-step(0.5)Hzintervalsoverarangeof
427.5–452.5Hz(Hertz)byusingtheE5andF5keys.
• WhilepressingandholdingdowntheA
#
7, B7, and C8 keys (on the right side of the
keyboard),presstheE5keyrepeatedlytolowerthepitchin0.5Hzsteps,ortheF5
key repeatedly to raise the pitch in 0.5Hz steps.
• To resetthepitchto440Hz,pressandholddown the A
#
7, B7, and C8 keys, and
presstheE5andF5keyssimultaneously.
Thedefaultseing(whenyouturnontheunit)is“440Hz(A4),”unlessacertiedser-
vicetechnicianhaschangedthedefaultseingto441,442,443,444,or445Hzduring
installation.