Korg iM1 - Page 22

Available Parameters by Mode
22
OSC
BALANCE...................................................................... [–50…+00…+50]
This parameter controls the relative mix of the two oscillators.
If the Program's "OSC MODE" is Double, this adjusts the vol-
ume balance of OSC1 and OSC2. The adjusted value is added
to the OSC1 "OSC LEVEL," and subtracted from the OSC2
"OSC LEVEL."
VDF
RESONANCE.................................................................. [–50…+00…+50]
This parameter adjusts the VDF (Filter) resonance level. The
adjusted value is added tothe VDF1 and VDF2 "RESO-
NANCE."
This setting is unavailable if the OSC page "RESO-
NANCESwitch" (page 29) is OFF.
CUTOFF ........................................................................ [–50…+00…+50]
This parameter adjusts the VDF cutoff level (frequency). The
adjusted value is added to the VDF1 and VDF2 "CUTOFF."
VDF EG INT ................................................................... [–50…+00…+50]
This parameter adjusts the VDF EG INT (Envelope Generator
Intensity).
The adjusted value is added to the VDF1 and VDF2 "EG INT."
VDF&VDA EG
ATTACK TIME .................................................................[–50…+00…+50]
This parameter simultaneously adjusts the VDF EG and VDA
EG attack time. The adjusted value is added to the "Attack
Time" of each EG (Envelope Generator).
DECAY TIME...................................................................[–50…+00…+50]
This parameter simultaneously adjusts the VDF EG and VDA
EG decay time. The adjusted value is added to the "Attack
Time" of each EG.
RELEASE TIME................................................................[–50…+00…+50]
This parameter simultaneously adjusts the VDF EG and VDA
EG release time. The adjusted value is added to the "Attack
Time" of each EG.
INSERT FX
IFX BALANCE..................................................................[–50…+00…+50]
This parameter adjusts the balance between the Insert effect's
processed sound and the direct sound. The adjusted value is
added to the "DRY/WET" setting of each effect. If a composite
effect (Delay/Hall - Delay/Tremolo) is selected, the adjusted
value is added to both of the "DRY/WET" settings.