Korg Kaossilator Pro - SD Card Formatting; Saving Data to SD Card

17
Checking the remaining capacity
of the card
Here is how you can display the remaining ca-
pacity of the SD card.
1. Hold down the SHIFT button and press the
PROGRAM MEMORY 1 (CARD) button.
2. Use the PROGRAM/BPM knob to select
“FrEE” (remaining card capacity).
3. Press the PROGRAM/BPM knob to view
the remaining capacity of the card.
Press the TAP TEMPO button (lit orange) to
return select another parameter, press the
SHIFT button to return to normal operation.
Formatting the SD card
Before you can use an SD card, you must format it on
the KAOSSILATOR PRO. The card may not work if it was
formatted on another device.
All data on the card will be lost when you format it.
1. Hold down the SHIFT button and press the
PROGRAM MEMORY 1 button.
2. Use the PROGRAM/BPM knob to select
“ForM.”
3. Press the PROGRAM/BPM knob; the dis-
play will indicate (No.)
4. Use the PROGRAM/BPM knob to select
(Yes) and press the PROGRAM/BPM
knob to format the card. When formatting
is complete, the display will indicate
(End.)
Press the TAP TEMPO button (lit orange) to
return select another parameter, press the
SHIFT button to return to normal operation.
Never turn off the power or remove the SD card while
data is being formated. Doing so may render the SD card
unusable.
If an SD card operation fails, the display will indicate
“Err” (Error).
Saving to SD card
Here’s how you can save the loop recorder
data, program memories, and all settings onto
an SD card.
1. Hold down the SHIFT button and press the
PROGRAM MEMORY 3 (SAVE) button.
2. Use the PROGRAM/BPM knob to select
the type of data that you want to save.
–
Loop recorder data
Contents of program
memory
MIDI, pad LED, and utility
settingdatale
The contents of “LoP.A”–
“LoP.D”, “Prog,” and “GLob”
combinedinasinglele
3. Press the PROGRAM/BPM knob; the dis-
playwillshowthelenumbers(0–9,or0–99
for loop recorder data) that can be saved. Use
the PROGRAM/BPM knob to select the le
number in which you want to save the data.
Anewlewillbeadded.
Thedatawilloverwriteanexistingle(in
thiscase,le1).
Thereisanidentically-namedleor
folder that cannot be rewritten.
4. To execute the Save operation, press the
PROGRAM/BPM knob, then use the PRO-
GRAM/BPM knob to select (Yes), and
nallypressthePROGRAM/BPMknob.When
saving is completed, the display will indicate
(End.) Press the SHIFT button to return
to the program indication.
Never turn off the power or remove the SD card while
data is being saved. Doing so may render the SD card unus-
able.
TIP: If the SD card is protected, the display will in-
dicate “Prct” and it will not be possible to save. Re-
move the card, turn off write protect, and try the op-
eration again.