Korg Kaossilator Pro - Using an SD Card (Continued)

19
4. To view the contents of the KAOSSILATOR
PRO’s card, open the drive that was added to
your computer in step 2.
Copy the desired data onto your computer.
You can also copy data from your computer
onto the card.
5. Exit USB mode.
In Explorer or My Computer, right-click the
“Removable Disk” icon and choose “Remove.”
Then press the KAOSSILATOR PRO’s SHIFT
button to exit USB mode.
When you’re ready to disconnect the KAOSSILATOR
PRO from your computer, you must rst exit USB mode and
then disconnect the USB cable.
MacOSX users (OSX 10.4 or later)
1. Use a USB cable to connect the KAOSSI-
LATOR PRO to your computer.
Plug the USB connector into the KAOSSILA-
TOR PRO’s USB connector. Make sure that
the connector is oriented correctly, and insert
it as far as it will go.
2. Hold down the SHIFT button and press the
PROGRAM MEMORY 7 (USB) button.
The display will indicate “buSy.”
3. The drive name of the card in the card slot
will appear on your computer.
While this screen is shown, you must not disconnect
the USB cable, remove the card from the slot, or switch the
power of your computer on or off. Doing so may damage
the data.
4. To view the contents of the KAOSSILATOR
PRO’s card, open the drive that was added to
your computer in step 2.
Copy the desired data onto your computer.
You can also copy data from your computer
onto the card.
5. When you’re ready to disconnect the KA-
OSSILATOR PRO, drag the drive from the
desktop into the Trash.
Then press the KAOSSILATOR PRO’s SHIFT
button to exit USB mode.
When you’re ready to disconnect the KAOSSILATOR
PRO from your computer, you must rst exit USB mode and
then disconnect the USB cable.
About the contents of the card
Thefollowinglesandfolderswillbecreated
in the root directory of the card.
Files you can save
LOOP REC Data 00–99.KOS
GLOBAL 0–9.KOG
PROGRAM MEMORY Set 0–9.KOP
All Data 0–9.KOA
Files you can load
LOOP REC Data 00– 99.KOS
00– 99.WAV
00–99.AIF
GLOBAL 0–9.KOG
PROGRAM MEMORY Set 0–9.KOP
All Data 0–9.KOA
TIP:
If anAll data le named “0.KOA”existsonthe
card,thislewillautomaticallybeloadedwhenyou
start up the KAOSSILATOR PRO.
TIP:
TheWAVEorAIFFlesthatcanbeloadedmust
be8/16-bitlinearPCMmonoorstereoles.Datathat
is other than 16-bit will be handled by discarding the
bits below 16 bits or by lling the lacking bits with
zeros. Youmustplacethe lesinthe root folder of
the SD card.
TIP:
Since WAVE and AIFFlesdonotcontainthe
tempo or length settings needed for playback on the
KAOSSILATOR PRO’s loop recorder, the tempo and
length will automatically be set to appropriate values
whentheleisloaded.Ifthedataislongerthancan
be recorded in one bank, it will be truncated. If the
data is shorter than can be recorded in one bank, the
remaining length will be handled as silence.