- 58 -
you could just use the first method I explained above. For example, let’s
say you want to use KARMA Module A on the Bass (Track 2, Channel 2).
Leave your keyboard on Track 01, put your external seq on Track 2, and
then in (6.1-2), assign Module A Input/Output to Channel 2.
40. It appears that in SEQ mode I can’t audition (solo) one timbre
at a time (to change the program e.g.).
You can’t “solo a track” in Seq mode unless there is data recorded on it.
To solo the track(s) that are being played by the KARMA function, use the
KARMA Module Solo checkbox on (6.1-1).
41. I’m trying to take the bass track out of one intro. I tried using
the mute track checkbox.
You can’t “mute a track” in Seq mode unless there is data recorded on it.
If the track has actual sequence data recorded, you should be able to
mute it with the Track Mute function. Make sure that you don’t have
more than 1 track set to the same MIDI Channel - if so, you have to mute
all of them (perhaps). If it is a KARMA generated bass-line (real-time),
you need to uncheck the “Run” checkbox on (6.1.1).
42. Can you adjust the amount of default reverb (in Song Play
Mode)and have the adjusted setting become the default?
There is a Master Return Level on each of the 2 MFX. You can use this
to easily adjust the amount of reverb or chorus overall. For example,
MFX 2 is the Reverb, and the default return level is “50”. You can go to
the Master Effects and raise/lower the overall Reverb return level:
(7.3-1) [Menu]-[MFX]-[Setup] -> FX 2 Rtn.
This setting isn’t saved when you turn off the Karma, but if you do it
once when you turn the Karma on, it will stay how you set it even while
changing modes, etc. You could also store is as one of the 16 “User Song
Templates” and then use the UTILITY “Load Template Song” to load it
whenever you want.
To Next Page
Loading...
