- 66 -
Section 8: KARMA Function (26)
1. How can I change KARMA Scenes with a footswitch?
1) In the Global Mode, go to (6.1-1) [Menu]->[Ctrl]->[Foot].
2) Set Foot Switch Assign to “Foot Sw CC #82”.
3) (6.1-3) [KARM2] -> Scene -> Set to CC #82.
4) Plug an additional footswitch into the back jack labeled “Foot Switch”.
☞ Parameter Guide, Pages 145-146.
You can now change Scenes with the Footswitch - if it is a toggle type
footswitch, it will change back and forth each time you press it. If it is a
damper pedal type footswitch, it will change Scenes as long as you hold it
down.
Doing it this way, you can still have a regular damper pedal plugged in to
damper, and get both effects. Or you could skip step 1 and 2, and just
set step 3 to CC #64 and use the damper to change scenes, but this
might interfere with normal damper settings.
2. How do I use a footswitch to change individual RT Controls?
Here’s an example using Program A004: ![Tricky Kit]!
1) Make sure you have your damper pedal plugged in to the Damper
jack.
2) Check the top-level K.RTC Page (1.1-4). Here, we can experiment a bit
and find that turning KARMA SW1 on/off brings in an additional drum
pattern for more complexity. We can also find that knob 8 controls
adding repeats to the beat. We will substitute foot switch control for
these.
3) (6.4-3) [Menu]->[K RT]->[DynMIDI]. Set the first row to look like this:
A/Damper #64 000/127 M RTParm Control
This routes the selected controller (Damper Pedal) into an RTParm
Control “matrix”.
4) (6.3-1) [Menu]->[K GE]->[GE P..4]. Here, we need to locate the parms
that we want to control with the pedal. We find that Parm #2 is the one
that is currently assigned to SW1. So instead, we assign it to “Dyn1”
(row 1 of the Dynamic MIDI settings we just set up. If we had used row 2
to make the damper assignment, we would set this to Dyn2.) Test it out
- you can now turn the additional drum pattern on/off with the damper.
5) (6.3-3) [GE P..12] Here we can locate Parm #9, Repetitions, which is
set to Knob 8. So we change this also to “Dyn1”, and now the pedal is
bringing in the extra pattern AND adding repeats. Want the repeats
To Next Page
Loading...
