- 71 -
Notice the “T” (Toggle) setting for “Action” - this is so we can use the
Chord Triggers to toggle off/on the mutes. If you wanted them to just be
muted while being pressed, you could use the “M” (Momentary) Setting.
At this point, we have routed the Chord Triggers into the Dynamic MIDI
section, and passed them all through to “RTParm Control” (into the
RTParms Matrix). Now we have to set that part to receive these and
perform the muting/unmuting:
(6) Go to (6.4-1) [Menu]-[K.RT]-[RTP..4] Get rid of whatever is already set
up and make it look like this:
Mix Run +0001 +0000 +0000 [x][ ][ ][ ] Dyn1
Mix Run +0001 +0000 +0000 [ ][x][ ][ ] Dyn2
Mix Run +0001 +0000 +0000 [ ][ ][x][ ] Dyn3
Mix Run +0001 +0000 +0000 [ ][ ][ ][x] Dyn4
Note the “Dyn” (Assign) settings (IMPORTANT). This is how we tell the
rows here which row of the Dynamic MIDI section they are listening to.
So, as you can see, we have created a sort of “matrix” whereby CC04 is
routed to Mix/Run on Module A, Damper 64 is routed to Mix/Run on
Module B, etc. Also pay attention to the zeros and ones (IMPORTANT) ;-)
This is what allows the modules to come up in Run when loaded, and
then the first push of a Chord Trigger Mutes it. And now, the stunning
finale - check it out. It actually works!
8. Is there a way to change the GE Number of a KARMA Module in
the middle of a song via some sort of MIDI message?
The only way that you can do this would be through SysEx control
(System Exclusive), using an external sequencer. In other words, nearly
all of the parameters in the Korg that the user can see are able to be
changed using SysEx messages. The question is whether your external
sequencer will allow you to do this in an easy or intuitive fashion. Note
that the internal Karma/Triton Sequencer does not support recording or
transmitting SysEx messages at this time.
The MIDI/SysEx spec is available on my site at:
http://www.karma-lab.com -> [Specs, Manuals & Updates]
From the spec:
(21) PARAMETER CHANGE R , T
F0, 42, 3g, 5D Excl Header
41 Function
0000 mmmm Mode (*18)
To Next Page
Loading...
