Korg Krome

EnglishFrançaisDeutschEspañol
Using the sequencer
En-15
Using the sequencer
Recording your performance
Auto Song Setup
TheAutoSongSetupfeaturecopiesthecurrent
ProgramorCombinationintoaSong,andthenputs
thesysteminrecord‐readymode.Wheninspiration
strikes,youcanusethisfunctiontostartrecording
immediately.TodosofromProgrammode:
Selecttheprogramthatyouwanttouseforrecording.
Ifdesired,youcanturnontheARPorDRUMTRACK
buttonstoaddanarpeggiatorordru
mkit
performance.
1. WhileholdingdowntheENTERbutton,pressthe
SEQUENCERREC()button.
Themessage“Doyoucontinue?”willappearinthe
SetuptoRecorddialogboxinthedisplay.
2. PresstheREC()buttononceagain.
(Alternatively
,youcanusetheOKbuttonorthe
ENTERbutton.)
TheKROMEwillautomaticallyswitchtoSequencer
modeandentertherecord‐standbystate,andtheclick
willbeginsoundingintimewiththetempo(
).Adjust
thetempo()asdesired(see“TEMPOcontrols”on
page 6.).
3. PresstheSTART/STOP()buttontostartthe
sequencerandbeginrecording.
Withthedefaultsettings,therewillbeatwomeasure
count‐downbeforerecordingstarts.
4. Playwhatyou’dliketorecord,andthenpressthe
START/STOP()buttontostoprecording.
Thesequencerwillautomatica
llyreturntothe
beginningoftheSong.
5. PresstheSTART/STOP()buttontohear
whatyourecorded.
SinceyoustartedinProgrammode,yourplayingwill
havebeenrecordedonTrack1.IfyouusedtheDrum
Track,itwillhavebeenrecordedonTrack10.For
Combinations,moretracksareusedasneeded.
Adding another track
Let’saddanothertracktotheperformancethatyou
recordedusingAutoSongSetup.
1. PressthePreferencetabtoaccesstheP0–1:
Play/REC–Preferencepage.Attheright,clearthe
“MultiREC”checkbox.
Note:AutoSongSetupturnsthisontorecordthe
Program’sDrumTrack,ormultiplechannelsina
Combination.
2. PresstheProg1–8tabtoaccesstheP0–1:
Play/REC–Pro
gramT01–08page.
3. BelowtheSongname,opentheTrackSelect
popupandselectMIDITrack02.
Thiscontrolsboththetrackthatyouplayfromthe
keyboard,and(withMultiRECturnedoff)thetrack
that’s recorded.
4. UsingtheCategoryorBank/ProgramSele
ctpopup
menus,selectaProgramfo
rTrack02.
5. IfyouhadturnedontheARPandDRUMTRACK
buttons,turnthemoff.
6. PresstheLOCATE()buttontogobacktothe
startoftheSong.
7. PresstheREC()buttontoenablerecording,and
thenpresstheSTART/STOP()buttonto
start.
8. Playwhatyou’
dliketorecord,andthenpressthe
START/STOP()buttonwhenyou’redone.
Multi REC
T
rack
Select
T
rack 2
Program