Korg Pa5X - Playing the Chord Sequences

PlayingtheChordSequences |183
Playing the Chord
Sequences
Starting and stopping a Chord
Sequence
1 If a Chord Sequence is available but not activated, the CHORD > SEQUENCE
indicator will appear white. If it is o, load a Chord Sequence as shown above.
2 Enable the Chord Sequence by pressing the CHORD > SEQUENCE button. If
the Player is stopped, its indicator will start ashing with the color of the current
Player. If it is playing, its indicator will be steady on.
As an alternative, use the Start Seq button in the Home > Chords pane to enable
the Chord Sequence.
3 Start the Player. The Chord Sequence will immediately start playing. If the
Player was already running, the Chord Sequence will start playing from the next
measure.
4 Play your solo part, while the Chord Sequence plays the chords for you.
During Chord Sequence looping, you can freely select any Fill or Variation, as if
you were playing chords with your hands.
5 Press the CHORD > SEQUENCE button again to disable the Chord Sequence.
The button indicators will return white.