Korg Pa5X - Choosing your preferred Keyboard Set

22| Let’sstart!
Powering up
Turning the instrument on
Connecting the power cable
Plug the supplied power cable into the POWER socket on the back of the instru-
ment, and the cable plug into a wall power socket.
When the cable is connected, the instrument is in standby.
WARNING: When the instrument is in standby, it is still connected to the power
line. Accessing the inside of the instrument can be dangerous. To completely dis-
connect the instrument from the power, unplug the power plug from the power
socket on the wall.
Turning the power on or o
▪ Turn the instrument on
> Press the POWER ( ) button to turn the instrument on (that is, ‘exit from
standby’). After you turn the instrument on, wait for the welcome screen to disap-
pear, then the Main page will be shown in the display.
▪ Turn the instrument o (standby)
> Keep the POWER ( ) button pressed for about two seconds, then release it
when the screen appears dimmed. The shutdown procedure will begin and last for
a few seconds. Please do not disconnect the power cable during this procedure.