Korg Pa5X - Page 350

340| DigitalDrawbars
Amplier
This is a detailed model of the amp of a classic tone-wheel organ, producing a
warm, fat tone. With the addition of the 3-band EQ, this amp simulation will allow
you to create a very versatile distortion.
Please note that these parameters can only be accessed if the CX-3 Amp eect
is selected.
Parameters Values Meaning
On/O On,O UsethisswitchtoenableordisabletheAmplier.
Gain 0…100 Thisadjuststhepreampgain,thereforetheoverdrive.Withhigh-
erGainvalues,youcanreachheavydistortion;withGain=0,the
ampwillalwaysremainclean.
IfanExpressionpedalisconnected,youcanuseittocontrolthe
amountofoverdriveanddistortion(byassigningittheDrawbars
Overdrivefunction).
Bass -10…10 Adjuststhebassfrequencies.
Middle -10…10 Adjuststhemiddlefrequencies.
Treble -10…10 Adjuststhetreblefrequencies.
Level 0…100 Amp’soutputlevel.
Master Eects (FX1-3)
You can use the FX1, FX2 and FX3 buttons to enable or disable the corresponding
send to the master eects.