28
5. AUTO WAH
This models an auto wah unit that automatically applies a wah effect according to
your picking dynamics (i.e., the strength with which you pick the strings). As with
the VOX WAH, you can select either V847 or V848 as the wah type.
6. U-VIBE/PHASE (VIB/PHAS)
This lets you select one of three models; a famous phase/vibrato effect with a
pedal, a wide-range four-stage phaser that was made in Denmark and packaged
in a black box, and a popular four-stage phaser that came in a banana-colored
box. Use the TYPE knob to select the model.
HINT:
If you assign the Speed to be controlled by the expression pedal, you’ll be
able to control the vibrato speed just as on the original phase/vibrato unit with
pedal that’s being modeled.
7. CHORUS/FLANGER (CHO/FLNG)
This is a chorus/flanger unit with a standard circuit structure.
[1] “SENS/POL” 0u–10u, 0d–10d Adjusts the sensitivity of the wah to the vol-
ume of your guitar.
[2] “ATTACK” 1.0–10.0 * Adjusts the response speed.
[4] “TYPE” 847/848 Selects either V847 or V848 as the wah
type.
[5] “ORDER” PrE(PRE)/
PoS(POST)
Selects the connection order. PRE/POST
connects the wah before/after the Drive/
Amp Model.
[1] “DEPTH” 0.0–10.0 * Adjusts the vibrato/modulation depth.
[2] “SPEED” 0.1–10.0 [Hz] * Adjusts the vibrato/modulation speed.
[3] “MANUAL” 1.0–10.0 * Adjusts the center frequency of the sweep.
MANUAL has no effect if DEPTH is set to
10.0.
[4] “TYPE” U-1, U-2, Or, bL Selects the type.
U-1: U-VIBE set to Vibrato mode.
U-2: U-VIBE set to Chorus mode.
Or: Models the popular four-stage phaser.
bL: Models the Danish phaser.
[5] “ORDER” PrE(PRE)/
PoS(POST)
Selects the connection order. PRE/POST
connects the effect before/after the Amp
Model.
[1] “DEPTH” 0.0–10.0 * Adjusts the modulation depth.
[2] “SPEED” 0.1–10.0 [Hz] * Adjusts the modulation speed.
[3] “MANUAL” 1.0–10.0 * Adjusts the center frequency of the sweep.
MANUAL has no effect if DEPTH is set to
10.
[4] “RESO” 0.0–10.0 * Adjusts the amount of resonance.
To Next Page
Loading...
Need help?
General
