53
IntroductionPanel TourSetupPlayingCreating
and Storing
Effect TypePedals
ESS
Index
MIDI/DIGITAL
Factory
settings
Trouble-
shooting
Spec. TunerAppendix
Restoring the Factory Preset
Programs
ere’s how you can restore the AX3000G’s programs and settings to the
state in which it was shipped from the factory.
NOTE: Executing this procedure will erase all the programs you created and saved
in the AX3000G, and will load the factory-set programs. MIDI settings will also be
initialized. If there are any settings you want to keep, you should first use the data
dump function to back them up, or use the “Program sheet” (the fold-out inside the
back cover of this manual) to write down your settings.
1. While holding down the three buttons ▲/▼, and EXIT switch, turn on the
power.
The display will read “P” and the LED 1–4 buttons will blink, and the name dis-
play will ask “RELOAD?” Release the three buttons you were holding down.
2. If at this point you decide that you really don’t want to execute this operation,
you can press the EXIT switch.
3. Press the WRITE button. The name display will show “LOADING,” and the fac-
tory-set data will begin being reloaded.
When reloading has been completed, the name display will indicate “COM-
PLETE,” and the AX3000G will automatically switch to Program Select Mode.
NOTE: Never turn off the power while this reload operation is occurring.
H
To Next Page
Loading...
Need help?
General
