32
NOTE: If P2 or P3 is selected, the speed is adjusted by the SPEED 1 (value knob
2).
6. TEXTREM
This models the popular tremolo circuit that’s built into the BLACK 2x12 model. The
SPREAD setting lets you produce a panning effect that spreads to left and right.
7. ROTARY
This models a stereo rotary speaker. When you adjust the speed, it will take a cer-
tain amount of time for the specified speed to be reached – just like on an actual
rotary speaker. This is because it takes several seconds for the motor that creates
the rotation to accelerate or decelerate.
P2: PHASER 1/2 are connected in parallel,
and their LFOs are synchronized (Stereo
mode).
P3: PHASER 1/2 are connected in parallel,
and their LFOs are synchronized in oppo-
site phase (Stereo mode).
[1] “DEPTH” 0.0–10.0 * Adjusts the tremolo depth.
[2] “SPEED” 1.0–10.0[Hz] * Adjusts the tremolo speed.
[4] “SPREAD” 0.0–10.0 Adjusts the left/right spaciousness.
[5] “LEVEL” 1.0–10.0 * Compensates the output level.
[1] “DEPTH” 0.0–10.0 * Adjusts the modulation depth.
[2] “SPEED 1” 0.1–10.0[Hz] * Adjusts the rotational speed of the speaker. If
you assign “ROT SPD” to the CONTROL
switch, this will be the SLOW speed. This
knob is effective even if you’re not using the
CONTROL switch.
(p.43 Control switch set-
tings)
[4] “SPEED 2” 0.1–10.0[Hz] * Adjusts the rotational speed of the speaker. If
you assign “ROT SPD” to the CONTROL
switch, this will be the FAST speed. This
knob will not function if you’re not using the
CONTROL switch.
(p.43 Control switch set-
tings)
[5] “ACCEL” 1.0–10.0 * Adjusts the time it takes for the rotational
speed to change. With higher settings, the
change will take more time.
CONTROL
switch ROT SPD If you select “ROT SPD” as the CONTROL
switch setting, the rotation speed will alter-
nate between SLOW/FAST (SPEED 1/
SPEED 2) each time you press the CON-
TROL switch. This lets you control the effect
just as on an actual rotary speaker.
(p.43
Control switch settings)
To Next Page
Loading...
Need help?
General
