98
☞ For details on the master effects, refer to p.205 “8. Effect
Guide.”
9–1: Master FX
Here you can select the type of master effects, turn them on/
off, and make chain and master EQ settings. These parame-
ters are the same as in Program mode. ☞“Program 9–1: Mas-
ter FX (Master Effects)”
▼ 9–1: Page Menu Command
9–1A: Copy Master Effect
☞ Program P9: 9–1A: Copy Master Effect.
However, the MIDI control channel specified in “Ctrl Ch” of
the MFX 1 and 2 pages will not be copied.
9–1B: Swap Master Effect
☞ Program P9: 9–1B: Swap Master Effect.
However, the MIDI control channel specified in “Ctrl Ch” of
the MFX 1 and 2 pages will not be swapped.
9–1C: Put Effect Setting to Track
This command inserts effect settings into a track as exclusive
events. You can use this to make the effect settings change
during a song.
☞ Sequencer P8: 8–1D: Put Effect Setting to Track.
9–2: MFX 1
9–3: MFX 2
Here you can set the parameters of the MFX 1 and 2 effects
that were selected in the Master FX page (☞p.217–).
9–2(3)a: Ctrl Ch
Ctrl Ch [Ch01...16, Gch]
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for the master effects. If Gch is
selected, the global MIDI channel “MIDI Channel”
(Global P1: 1–1a) will be used.
9–4: Master EQ
The master EQ is a three-band stereo EQ. It is used to per-
form overall equalizing (tonal adjustment) on the sound
from the L/R bus immediately before it is output to AUDIO
OUTPUT (MAIN OUT) L/MONO and R (☞p.269).
9–4a: Ctrl Ch
Ctrl Ch [Ch01...16, Gch]
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for the master EQ. If Gch is
selected, the global MIDI channel “MIDI Channel”
(Global P1: 1–1a) will be used.
Sequencer P9: Master Effect
9–1
9–1c
9–1a
9–1b
0–1A
9–1A
9–1B
0–1I
0–1J
9–1C
9–1
9–2a
0–1A
9–4a
To Next Page
Loading...
