EasyManua.ls Logo

Korg TRITON Extreme - Combination P9: Edit-Master FX; 9-1: Master FX; 9-2: Mfx 1; 9-4: Master EQ

Korg TRITON Extreme
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
53
Combination
P0
P1 P2 P3 P4 P7 P8 P9
For details on master effects, refer to p.205 “8. Effect
Guide.”
9–1: Master FX
Here you can select the type of each master effect, turn it
on/off, and make chain and master EQ settings.
9–1a: MFX1, 2
MFX1, 2 [000...089]
MFX1, 2 On/Off [Off, ON]
Chain [Off, On]
Chain Direction [MFX1MFX2, MFX2MFX1]
Chain Signal [LR Mix, L Only, R Only]
Chain Level [000...127]
9–1b: Return Level
Return 1, 2 [000...127]
9–1c: Master EQ Gain [dB]
Low [–18.0...+18.0]
Mid [–18.0...+18.0]
High [–18.0...+18.0]
These settings are the same as in Program mode (“Pro-
gram 9–1: Master FX”).
9–1: Page Menu Command
9–1A: Copy Master Effect
Program P9: 9–1A: Copy Master Effect.
However, the MIDI control channel that is specified by “Ctrl
Ch” of the MFX 1 and 2 pages will not be copied.
9–1B: Swap Master Effect
Program P9: 9–1B: Swap Master Effect.
However, the MIDI control channel that is specified by “Ctrl
Ch” of the MFX 1 and 2 pages will not be swapped.
9–2: MFX 1
9–3: MFX 2
Here you can set the parameters for the MFX 1 and 2 effects
that were selected in the Master FX page (p.217–).
9–2(3)a: Ctrl Ch
Ctrl Ch [Ch01...16, G ch]
This parameter specifies the MIDI channel that will
control dynamic modulation (Dmod) for the master
effect.
G ch: The global MIDI channel “MIDI Channel” (Global P1:
1–1a) will be used for control. Normally you will set this to
G ch.
9–4: Master EQ
The master EQ is a three-band stereo EQ. It is located imme-
diately before the AUDIO OUTPUT (MAIN OUT) L/
MONO and R from the L/R bus, and adjusts the overall
tonal character of the sound (p.269).
9–4a: Ctrl Ch
Ctrl Ch [Ch01...16, G ch]
This parameter specifies the MIDI channel that will
control dynamic modulation (Dmod) for the master EQ.
G ch: The global MIDI channel “MIDI Channel” (Global P1:
1–1a) will be used for control. Normally you will set this to
G ch.
The MEQ High Gain and MEQ Low gain can be controlled
by assigning a modulation source to the “Low Gain Mod-
Src:” and the “High Gain Mod-Src:” functions on this page.
Combination P9: Edit–Master FX
9–1
9–1c
9–1a
9–1b
0–1A
9–1A
9–1B
9–1
9–2a
0–1A
9–4a

Table of Contents

Other manuals for Korg TRITON Extreme

Related product manuals